Sunday 29-Sep-2013, 09:29 PM
The last and the biggest mould has been completed and tested!
![[Image: 1237473_10151752051489652_1169693483_o.jpg]](https://fbcdn-sphotos-e-a.akamaihd.net/hphotos-ak-prn2/1237473_10151752051489652_1169693483_o.jpg)
I did encounter the usual air pocket problems, but with some quick rocking of the mould next time should get rid of all that
I did use Barnes' Easycast which sets just a little too quick for my liking. May try 4PU again on the next one.
![[Image: 892557_10151752041454652_990928018_o.jpg]](https://fbcdn-sphotos-h-a.akamaihd.net/hphotos-ak-frc3/892557_10151752041454652_990928018_o.jpg)
![[Image: 882820_10151752041539652_1554578722_o.jpg]](https://fbcdn-sphotos-f-a.akamaihd.net/hphotos-ak-ash3/882820_10151752041539652_1554578722_o.jpg)
![[Image: 1277016_10151752041604652_1853982470_o.jpg]](https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-prn2/1277016_10151752041604652_1853982470_o.jpg)
I'll trial a couple more runs...after that I'll be working out a final price, write up the assembly instructions and draw up the templates for the PVC pipes needed.
I did encounter the usual air pocket problems, but with some quick rocking of the mould next time should get rid of all that
I did use Barnes' Easycast which sets just a little too quick for my liking. May try 4PU again on the next one.I'll trial a couple more runs...after that I'll be working out a final price, write up the assembly instructions and draw up the templates for the PVC pipes needed.
"I find your lack of pants disturbing."
:DW13: